It has been long time since HSDPA and HSUPA came into existence. Untill now we have read and implemented many features related to HSDPA and HSUPA. However following are the basic difference between HSDPA and HSUPA:
- In the downlink, the shared resource is transmission power and the code space, both of which are located in one central node, the NodeB. In the uplink, the shared resource is the amount of allowed uplink interference, which depends on the transmission power of multiple distributed nodes, the UEs.
- The scheduler and the transmission buffers are located in the same node in the downlink, while in the uplink the scheduler is located in the NodeB while the data buffers are distributed in the UEs. Hence, the UEs need to signal buffer status information to the scheduler.
- The WCDMA uplink, also with Enhanced Uplink, is inherently non-orthogonal, and subject to interference between uplink transmissions within the same cell. This is in contrast to the downlink, where different transmitted channels are orthogonal. Fast power control is therefore essential for the uplink to handle the near-far problem. The E-DCH is transmitted with a power offset relative to the power-controlled uplink control channel and by adjusting the maximum allowed power offset, the scheduler can control the E-DCH data rate. This is in contrast to HSDPA, where a (more or less) constant transmission power with rate adaptation is used.
- Soft handover is supported by the E-DCH. Receiving data from a terminal in multiple cells is fundamentally beneficial as it provides diversity, while transmission from multiple cells in case of HSDPA is cumbersome and with questionable benefits as discussed in the previous chapter. Soft handover also implies power control by multiple cells, which is necessary to limit the amount of interference generated in neighbouring cells and to maintain backward compatibility and coexistence with UE not using the E-DCH for data transmission.
- In the downlink, higher-order modulation, which trades power efficiency for bandwidth efficiency, is useful to provide high data rates in some situations, for example when the scheduler has assigned a small number of channelization codes for a transmission but the amount of available transmission power is relatively high. The situation in the uplink is different; there is no need to share channelization codes between users and the channel coding rates are therefore typically lower than for the downlink. Hence, unlike the downlink, higher order modulation is less useful in the uplink macro-cells and therefore not part of the first release of enhanced uplink.
Tidak ada komentar:
Posting Komentar